1991 525I BMW
I have change the oil and everything else but I need to reset it and need some help.
Ihave heard of useing a wire and also soemthing about the trip switch on the dash hold for 5 seconds an so on can anyone tell me how to do this?
Thanks alot!1991 BMW Service Light reset for oil change (How To?)?I had a '91 320i. I heard it was under one of the pedals (gas, brake, clutch?) in mine. I don't remember which one. To the GM Tech - I bought this car after owning a crappy GM car. I had more satisfaction with my Beemer.1991 BMW Service Light reset for oil change (How To?)?buy american or go to wher your pos was made for your answer.1991 BMW Service Light reset for oil change (How To?)?check with ur dealer its free and will get the proper anser most of the time1991 BMW Service Light reset for oil change (How To?)?well you need 2 wires a 12 volt lamp.
1 wire end to car body ,other end to lamp end
open the conector cap ,the round one with lots of pins
another wire to no 8 pin and other lamp pole,
(no 8 maybe differ from 520 which i own
but try other ends no risk
some has lit the lamp some dont
you will see the oil and every service indicator will be reset
i do it for 14 years!!1991 BMW Service Light reset for oil change (How To?)?K you need to go to local euro garage and they have a small hand held computer called a retreiver. It plugs into the round looking plug in your engine bay. takes 2 seconds they should do it for free!! You can NOT reset it your self. If you attempt to jump pins you can do dammage1991 BMW Service Light reset for oil change (How To?)?You might have to turn the ignition on and press the gas pedal three times. GM cars are the same way in that respect.
I wouldn't put with someone taking cheap shots at my ride either.1991 BMW Service Light reset for oil change (How To?)?Have a professional with the right tool reset the service light.1991 BMW Service Light reset for oil change (How To?)?I just answered this same question yesterday, but I will do it one more time. In order to reset the computer, you must remove the negative(-) cable from the battery for at least 5 seconds in order to reset the ECM (computer). I have this information in a book. Good Luck!